Kitz FBS - Page 20

Document No.:KE-4011-03 Page: 17/27
(5) Remove the cover from the housing (Fig.7).
Fig.7
(6) Loosen bolts and remove the end cover and the spring unit. O-rings are placed inside
the end cover and the spring unit (Fig.8).
Fig.8
(7) Loosen a hexagon headed bolt and remove a piston from the housing, by picking an
outside rib with pliers (Fig.9).
Fig.9
Bolt <35B>
Cover <2C>
Piston bearing <67C>
Bolt <13A>
O
-
ring <45D>
Piston <117>
Housing <1>
Gear rack <103>
O
-
ring <45A>
End cover <2A>
O-ring <45F>
Bolt <35>
End cover <2A>
Spring unit