Kitz Y Series User Manual

DocumentNo.:KE-0015-00                                        Sheet:20/37

IIIStrainerInstallation


6.8Gradually raise the line temperature and pressure for pilot operation. Retighten all
threadedparts,ifneeded.

6.9 Incaseflangesarewelded topipes,DONOT installstrainers tothepipesuntil the
weldedflangescooldown.


6.10 Incasepaintedstrainersaresuspendedbyaslingbelt,protectthepaintedsurface
ofthestrainerbodywithcloth.


6.11 Forpaintedproducts,useawasherunderthepipenuttoprotectthepaintedsurfaceof
the end flange. Prepare appropriate bolts, nuts, washers and gaskets beforehand for
subsequentinstallation.

Kitz Y Series Specifications

General

Brand	Kitz
Model	Y Series
Category	Control Unit
Language	English