29
If the display flashes alternately with the heat setting this means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or,
• not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The display will automatically turn
off after 1 minutes if no suitable pan is placed on it
When you have finished cooking
1. Touching the heating zone selection control that you wish to
switch off.
2. Turn the cooking zone off by scrolling down
to”0”. Make sure the display shows”0”,then
show”H”.
3. Turn the whole cooktop off by touching the ON/OFF control.
4. Beware of hot surfaces: H will show which cooking zone is hot
to touch. It will disappear when the surface has cooled down
to a safe temperature. It can also be used as an energy saving
function if you want to heat further pans, use the hotplate
To Next Page
Loading...
