Charcoal Filter Installation
1. Please remove the interior of your cooker hood by removing the grease lters. These
are located at the bottom of the hood (see illustration above).
2. Inside the hood you will see the motor. This one has an air intake on the left and right
side.
3. Now place the activated carbon lters on the air inlets one after another and lock
them with a clockwise rotation. The lter will snap in and out audibly.
4. Close the interior of the cooker hood by reinserting the grease lters.
The extractor hood is now converted to recirculation mode. There is no special mode or
switch that needs to be activated.
How often should I change the lters?
Changing the lters depends on the frequency of use of the hood. As a general
guideline, they should be changed every 3 months if used regularly.
TROUBLESHOOTING
Fault Possible Cause Solution
Light on, but motor does
not work.
The leaf blocked. Get rid of the blocking.
The capacitor damaged. Replace capacitor.
The motor jammed
bearing damaged.
Replace motor.
The internal with of motor
off or a bad smell from the
motor.
Replace motor.
To Next Page
Loading...
