Klarstein AERO RING SMART - Page 42

42
EN
• The unit must be installed in an accessible location for installation and
maintenance, without obstacles that could block air inlets or outlets.
• The unit must be kept away from heat sources, ammable or explosive
conditions at all times.
Requirements for installation position
• Avoid areas where ammable, explosive or corrosive gases are present.
• Avoid places with strong articial electric/magnetic elds.
• Avoid places with high noise and resonance levels.
• Avoid severe natural conditions (e.g. heavy lampblack, strong sandy wind,
direct sunlight or high temperature heat sources).
• Avoid locations within reach of children.
• Select a location with good ventilation and easy access to the unit for service
and repair.
Installation environment inspection
• Check the nameplate on the unit to make sure the refrigerant is R290.
• Check the oor area of the room. The room must not be smaller than the
specied oor space of 12 m². The unit must be installed in a well-ventilated
location.
• Check the surroundings of the installation site: R290 must not be installed in
the closed, reserved space of a building.
Customerguide
• The customer must have a qualied power supply that matches the one
printed on the air conditioner's label.
• They must use a dedicated and ecient grounding outlet that matches the
plug of the air conditioner.
• The appliance must be installed in accordance with national regulations.
Select the best location
1. lnstall the mobile air conditioner in a at and spacious location where the air
outlets will not be obstructed.
2. A minimum clearance from walls or
other obstacles should be kept,
3. The gradient can't be more than 10
degrees with the horizontal plane, while
placing and using the unit. Uneven
ground may cause additional noise or
vibration, or lead to damage to the unit.
>50 cm
>50 cm