Klarstein Amazonia 6 - Adjusting Salt Consumption

38
EN
Note:Thesaltcontainermustonlyberelledwhenthesaltwarninglightinthecontrol
panel comes on. De- pending on how fully the salt dissolves, the salt warning light
maystillbeoneventhoughthesaltcontainerislled.Iftherearespillsofthesalt,a
soak or a rapid program should be run to remove the excess salt.
Adjusting Salt Consumption
Closethedoor,within60secondsafterpoweron,pressStart/Pausebuttonandhold
for 5 seconds, the machine will enter setting mode.
PresstheStart/pausebuttontoselectthepropersetaccordingtoyourlocalenvironment,
thesetswillchangeinthefollowingsequence:H1>H2>H3>H4>H5>H6.
There are 6 levels of salt consumption in all. It is recommended to select the level
according to below table:
Water hardness level
Setting on the
water softener
Digital Display stalls
°dH
1
mmol/l
2
0-5 0-0.9 1 H1
6-11 1.0-2.0 2 H2
12-17 2.1-3.0 3 H3
18-22 3.1-4.0 4
*
H4
23-34 4.1-6.1 5 H5
35-45 6.2-8.0 6 H6
¹ German degree of measurement for the water hardness
² International unit for water hardness
*
Factory setting
Note: Withoutanyoperationinveseconds,themachinewillexitfromsetmode,the
machine is into standby status.