Klarstein Amazonia 6 - Fill the Rinse Aid Dispenser

39
EN
Fill the Rinse Aid Dispenser
Therinseaidisreleasedduringthenalrinsetopreventwaterfromformingdropletson
your dishes. That can leave spots and streaks. It also improves drying by allowing water
to sheet off the dishes. Your dishwasher is designed to use liquid rinse aids. The rinse aid
dispenserislocatedinsidethedoornexttothedetergentdispenser.Tollthedispenser,
open the cap and pour the rinse aid into the dispenser until the level indicator turns
completely black. The volume of the rinse aid container is about 110 ml.
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and
spot and streak free drying. Rinse aid is automatically added during the last rinse,
ensuring thorough rinsing, and spot and streak free drying. Only use branded rinse
aidfordishwasher.Neverlltherinseaiddispenserwithanyothersubstances(e.g.
Dishwashercleaningagent,liquiddetergent).Thiswoulddamagetheappliance.
Rell Rinse Aid Dispenser
If there is no rinse-aid warning light in the control
panel, you can judge the amount of rinse-aid by the
colour of the optical level indicator located next to the
cap. When the rinse-aid container is full, the whole
indicator will be dark .As the rinse-aid diminishes, the
size of the dark dot decreases. You should never let the
rinseaidgetbelow1/4full.
1 Toopenthedispenser,turnthecaptothe„open“(left)arrowandliftitout.
2 Pourtherinseaidintothedispenser,beingcarefulnottooverll.
3 Replacethecapbyinsertingitalignedwith„open“arrowandturningittothe
closed(right)arrow.
Note: Cleanupanyrinseaidsplitduringllingwithanabsorbentclothtoavoid
excessive foaming during the next wash. Don‘t forget to replace the cap before you
close dishwasher door.