28
EN
1. The distance between the cooking surface and the lowest edge of the cooker
hood must be at least 65 cm (see Fig. 1).
2. Once the height is dened, install the anchoring in the appropriate place. To
do this, you must rst drill holes (you will need a drill, suitable drill bits, dowels
and screws) and then x the anchorage to the wall with the screws. After the
anchoring is xed, use the similar procedure to attach the internal clamp for
the replace facing (see Figure 2). Please pay attention to the correct distance
(please measure the distance), because the replace facing will be xed to the
clamp later.
3. Connect the pipe and place the hood on the anchoring (see picture 6).
4. Insert the glass part correctly and x them with the appropriate screws. Guide
the end of the pipe connection into the open. Please note that there must be
an opening necessary for this.
5. Set the correct height of the inner chimney facing so that the brackets match
and x them. After that you can x the hood with the safety screws (see
picture 7).
Note: Please note that the two safety caps are located on the back of the casing.
6
Extensible pipe
To Next Page
Loading...
