Klein Tools CL600 User Manual

10
ENGLISH
OPERATING INSTRUCTIONS
AC VOLTAGE (LESS THAN 1000V)
1. Insert RED test lead into VΩ jack
5
, and BLACK test lead into
COM jack
4
, and rotate function selector switch
2
to the
AC voltage
V setting.
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
DC VOLTAGE (LESS THAN 1000V)
1. Insert RED test lead into VΩ jack
5
, and BLACK test lead into
COM jack
4
, and rotate function selector switch
2
to the
DC voltage
V setting.
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
NOTE: If "–" appears on the LCD, the test leads are being applied to
the circuit in reverse. Swap the position of the leads to correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of order mV may appear on the display. This is noise and
is normal. By touching the test leads together to close the circuit
the meter will measure zero volts.
Black lead Red lead
Black lead Red lead

Klein Tools CL600 Specifications

General

Certification	CE
Clamp opening	35 mm
Product color	Black, Orange
International Protection (IP) code	IP40
Resistance (max)	60 Ω
Measuring category	CAT III 1000V, CAT IV 600V
Carrying case	Yes
Battery type	AAA
Number of batteries supported	2
Operating altitude	0 - 2000 m

Weight and Dimensions

Depth	97 mm
Width	231 mm
Height	39 mm
Weight	335 g