Tech Support: 1-800-KLIPSCH
13
B) Set the left/right stereo switch. “L” if it is the left
speaker, “R” if it is the right speaker. For additional
information see Selecting LightSpeaker
®
5 Locations
on page 16.
C) Your LightSpeaker
®
5 system allows you to install
up to 4 pair of (or 8 total ) speakers. If you are
installing more than one pair of LightSpeakers
®
5 you
will probably want to divide your home into zones. See
Complete System Manual or go to www.Klipsch.com.
Step 7: Installing your LightSpeaker
®
5 into the recessed
light fixture:
A) Easiest Install: If you skipped steps 4 and 5, and
your LightSpeaker
®
5 fits with no modifications, screw
it into the lighting fixture. Test your circuit by turning
on the circuit breaker and light switch from Step 1.
If the LED light does not come on after 5 seconds
remove and reinstall the LightSpeaker
®
5, check your
circuit breaker and try the switch again. You can now
skip to Step 9.
B) Simple Tab Install: If you did not skip steps 4 and
5, here’s how to use the SimpleTabs™ to install your
LightSpeaker
®
5:
To Next Page
Loading...
