Tech Support: 1-800-KLIPSCH
15
Step 9: Enjoy your Lightspeaker
®
!Helpful Hints
Installing and Removing the Lens:
A) Removal BEFORE your LightSpeaker
®
5 is installed.
1)
While holding the LightSpeaker
®
5
in the palm of
your hand rotate the unit until one of the holding tabs is
facing up.
2)
Using a common screwdriver or other small
flat object, gently push down and then out on
the tab, easing it out through the opening in the
LightSpeaker
®
5
housing.
CAUTION: Do not touch the LED or Speaker Baffle with
the lens off when the unit is hot, allow the unit to cool
down before touching the baffle.
3) When the lens pops up, gently pry it away from
the housing, being gentle and making sure not to
break the tabs.
To Next Page
Loading...
