Need help?Do you have a question about the Klipsch R-120SWI and is the answer not in the manual?
General| Type | Powered Subwoofer |
|---|---|
| Driver Size | 12 inches |
| Power Output | 200W RMS / 400W Peak |
| Frequency Response | 29Hz - 120Hz |
| Amplifier Type | Class D |
| Woofer Material | Cerametallic |
| Enclosure Material | MDF |
| Enclosure Type | Bass Reflex |
| Inputs | Line-level/LFE RCA |
| Low Pass Crossover | 40Hz - 120Hz |
| Phase Control | 0 / 180 degrees |
Verify components and check for transit damage immediately after unpacking. Contact seller if issues arise.
Corner placement enhances bass. Experiment with locations for best room acoustics and AC power access.
Shows amplifier status: green for active, dark for off. Consult documentation for details.
Select ON/AUTO for signal-activated power, or OFF for manual control. Auto standby activates after inactivity.
Set to match subwoofer output with main speakers. Overall volume controlled by system amplifier.
Determines crossover frequency for bass. Adjust based on main speaker size for seamless blending.
Acoustically aligns subwoofer output with main speakers for optimal sound integration.
Initiate wireless connection by holding SYNC for 3 seconds. Observe indicator light for status (flashing/solid blue).
Connect subwoofer to the receiver's LFE or LINE OUT port using an appropriate cable.
Link subwoofer to receiver's PRE OUT (Left/Right) ports using a Y-cable.
Use a dry cloth only. Avoid abrasive cleaners. Vacuum brush attachment is suitable for dust removal.
Register online for updates and promotions. Keep your receipt for warranty claims.
To Next Page
