Need help?Do you have a question about the Klipsch Reference Series RPW-10 and is the answer not in the manual?
Standard input accepting signals from pre-amp, subwoofer, or LFE outputs via RCA jacks.
Connects to main channel speaker outputs using 16-gauge or larger speaker wire for an alternative connection.
Allows selection of upper-frequency cutoff (40-120Hz) to blend subwoofer with main speakers.
Volume control to match subwoofer output level with main speakers.
Acoustically matches subwoofer output to main speakers. Select 0° or 180° for optimal output.
Main AC power switch for the subwoofer. Must be ON for operation.
Turns subwoofer on with signal detection and off after 20 minutes of no signal.
Standard input accepting signals from pre-amp, subwoofer, or LFE outputs via RCA jacks.
Connects to main channel speaker outputs using 16-gauge or larger speaker wire for an alternative connection.
Allows selection of upper-frequency cutoff (40-120Hz) to blend subwoofer with main speakers.
Volume control to match subwoofer output level with main speakers.
Acoustically matches subwoofer output to main speakers. Select 0° or 180° for optimal output.
Main AC power switch for the subwoofer. Must be ON for operation.
Turns subwoofer on with signal detection and off after 20 minutes of no signal.
General| Type | Powered Subwoofer |
|---|---|
| Driver Size | 10 inches |
| Frequency Response | 32Hz - 120Hz +/- 3dB |
| Amplifier Type | Class D |
| Woofer Material | Cerametallic |
| Enclosure Material | MDF |
| Enclosure Type | Bass Reflex via rear-firing port |
| Phase | 0-180 degrees |
| Inputs | L/R Line-Level RCA, LFE RCA |
| Outputs | Speaker-level |
| Crossover Frequency | 40Hz - 120Hz |
To Next Page