9
RETAIL CUSTOMERS RESPONSIBILITY UNDER THE KMC WARRANTY:
The retail customer’s responsibilities are:
1. To read the Operator’s Manual and operate the Ripper Bedder in accordance
with the instructions given in this manual.
2. To inspect the Ripper Bedder daily, lubricate as specified and repair or replace
parts as needed, especially when continued use would cause damage or exces-
sive wear to other parts.
3. To maintain and keep in place all safety shields and devices.
4. When warranty service is necessary, it is the customer’s responsibility to deliver
the machine to the KMC dealer from which it was purchased. Warranty repairs
should be submitted to the dealer within thirty (30) days of failure.
5. Dealer travel to the machine or hauling the machine to his shop for the purpose
of performing warranty service is not allowed under KMC warranty. It is a cost
to be paid for by the retail customer. Any arrangement whereby the dealer
agrees to absorb all or part of this cost is strictly between the dealer and the re-
tail customer.
SAFETY PROCEDURES:
Safety and performance are the primary
objectives of the designers of KMC
equipment. Safety features have been
incorporated into this machine where
possible and warnings given in other areas.
For your safety, PLEASE read and observe
the following safety procedures.
2. Do not permit anyone to ride on the
machine at any time.
3. Before starting or operating the machine,
make a walk-around inspection and check
for obvious defects such as loose
mounting bolts and damaged components.
Correct any deficiencies before starting.
(The equipment must be properly
maintained and guarded and must be
suitable to performing its task.)
1. All persons operating this piece of equipment should READ the Owner’s
Manual.
4. Keep all persons a safe distance away from the rear and sides of the machines
while it is in operation.
To Next Page
Loading...
Need help?
General
