KMC Controls 6800 User Manual

3
FORWARD
The 6800 Series Ripper Bedder is a heavy-duty deep tillage tool that is capable of
breaking the ground hardpan up to 18 inches deep, while forming and shaping beds above
ground in a variety of shapes and sizes. Reset on the Go Shanks for non-stop operation, with
the ability to clear obstructions and fully reset back in the ground without ever slowing down
and Toggle Trip Shanks offering the same superior load protection, but requiring lifting for full
reset.
INTRODUCTION:
TO THE PURCHASER
This KMC 6800 Series Ripper Bedder has been carefully designed and manufactured
to give years of dependable service. In order to operate it efficiently and maintain if properly,
please read the instructions within this manual thoroughly.
Some components of this machine are labeled left or right. The notations are determined by
standing behind the implement and facing the direction of forward travel.
After reading this Operator’s Manual, Please keep it for reference each season.
To insure procurement of the proper repair parts, please record your machine’s Serial Number
and Purchase Date as shown below:
Model No._______________________
Serial No.________________________
Purchase Date ___________________
Serial # Tag Location

KMC Controls 6800 Specifications

General

Brand	KMC Controls
Model	6800
Category	Farm Equipment
Language	English