404G2 SERIES TRACTOR OPERATION MANUAL
57
(1)If there is a fault in the electrical components, check whether the fuse in the
corresponding position of the line is burn out. If it has been broken, you can take a period of
fuse from the fuses, tightly fix it between two clamps, then plug the fuse back in place.
(2)If the installed fuses are defined but the fuse is often burned, which indicating that there
may be a line faults should be checked and excluded. It is not allowed to use multiple units
or increase the capacity of the fuse instead, or it will burn the electrical components in the
circuit.
(3) It is strictly forbidden to use copper wire or iron wire to replace the fuse, otherwise it
would lose the insurance function, and damage the electrical components in the circuit.
To Next Page
Loading...
