EasyManua.ls Logo

KNEGT 404G2 Series - Page 62

KNEGT 404G2 Series
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
404G2 SERIES TRACTOR OPERATION MANUAL
60
5.2.250hmaintenance
1. Engine: After 50 hours of light load working, the oil in the engine sump and
injection pump should be changed, at the same time, change the filter element;
clean the sump, the filter and the filter net with clean diesel.
2. Transmission system: After using for 50 hours, it will be needed to check the free
travel of the clutch pedal, and adjust it if necessary.
3. Accumulator: Check the accumulator of it’s electrical power, charge it if it is not
sufficient.
4. Use a press rod oil gun at these places: Left and right draft links, center link, tie rod
joints, steering cylinder shaft with pin hole.
5. Air Conditioning System: Check the connecting parts and hose, repair or fix the
parts when they are loose; check all the electrical connectors and wires, examine
and repair them if they are deviant.
5.2.3100hmaintenance
1. Engine
Change the oil in the sump, clean the filter strainer.
Change engine oil and diesel filter elements, and clean the cavity of filter.
Check the tension of fan belt, adjust it if loosed.
Check the level of injection pump, refill it if needed.
Clean the air filter and replace oil (Necessary to perform every time after
working in wet and muddy conditions).
2. Clutch: Check the free travel, adjust it if necessary.
5.2.4250hmaintenance
1. Transmission sysytemCheck the oil level of chassis, refill it if needed.
2. Front axleCheck the toe-in and the bearings of front axle (Two wheel drive),
adjust them is needed.
3. Accumulator: Smear Vaseline or calcic lubricant on the bolts of accumulator.
5.2.5500hmaintenance
1. Check the pressure and fogging quality of the engine oil pump, clean it if necessary.

Table of Contents

Related product manuals