404G2 SERIES TRACTOR OPERATION MANUAL
66
As Fig.6-2 shows, when assembling the clutch, make sure the clearance between release
bearing and release rod be 2mm， namely the clutch pedal free path should be about
25mm.
When adjusting,first,unscrew the adjusting nut 1 and 5, adjust the Clutch pull rod with a
wrench at the position of mark ‘a’to insure the pedal free path to be in the stated range,
tighten the adjusting nut 1 and 5, then adjust the Clutch pedal hold down bolt3 to make sure
the clearance between release bearing and release rod,and adjust the adjusting bolt 7 to
make sure the Security switch is in the open position at the same time, at last, tighten the
adjusting nut 2 and 6.
Fig 6-2
1. Adjusting nut A 2. Brake pull rod 3. Adjusting nut B 4.Connect cannula 5. Adjusting nut C
6. Adjusting nut D 7. Pull rod head part A 8. Adjusting nut E
To Next Page
Loading...
