504G3 SERIES TRACTOR OPERATION MANUAL
53
2、 Position Control
Lift link should lift implements when doing spreader or sprayer. Draft load sensing does not
work in this condition. You should adjust the depth with position control. See fig 4-21(b)
Fig 4-21（a） Fig 4-21（b）
Push the draft control lever all the way down
forward when using position control. Push the
position lever forward to put down the implements
and pull the position lever backward to lift the
implements.
Fig 4-21（c）
Operate in varying soil conditions. The implement is raised slightly automatically to get
through tough spots so you do not have to shift to a lower gear.
3. Float Control
On uneven ground we need the implement float with the ground contour. See figure
4-21(c)
Push position control lever all the way forward and draft control knob all the way down
forward so that implement can follow the ground contour.
NOTE: Lift links can be adjusted for implement float.
4. Draft and position control
Using draft and position control to control the depth applies operating in varied soil
conditions. The implement is raised slightly to get through tough spots so you do not
have to shift to a lower gear.
Push the position control lever all the way forward and the draft control lever backward.
Push the draft control lever forward slowly with the tractor moving until the desired
depth. Then pull the position control lever backward slightly until the lift arms tend to
lift.
To Next Page
Loading...
