KNF NF 100 - Installation Location and Position

Diaphragm liquid pump NF 100 Installation and connection
KNF Flodos BA_NF100_EN_10_067676.docx
Translation of original Operating and Installation Instructions 14
Fig. 8: Mounting dimensions NF 1.100 DCB
Fig. 9: Mounting dimensions NFB 100 DCB-4
 For pumps with fan: When installing the pump, make sure that
the motor’s fan can draw in an adequate amount of cooling air.
 Make sure that the installation location is dry and the pump is
protected against water in the form of rain, spray, splashes and
drips.
 Protect the pump against dust.
 Protect the pump against vibration and impact.
 Generally speaking, the pump can be installed in any position.
The venting and accuracy of one-headed pumps is optimal if
installed as shown in the illustration (Fig. 10).
Cooling air supply
Installation location
Installation
position
Fig. 10: optimum installation
position for one-headed pumps:
vertical