SafETy
5 Status: 26.10.21
2 Safety
Observe the following safety instructions when handling the product.
2.1 Intended use
The tool is intended for the following uses:
• Cutting cables (up to 6 mm²)
• Stripping cables (0.75 to 6 mm²)
• Crimping insulated terminals and plug type connectors (0.5 to 6 mm²)
on ne conductor cables
• Crimping unshielded, open plug type connectors (1.5 to 2.5 mm²)
with connector width 6.3 mm on ne conductor cable
• Cutting copper and brass threaded bolts (M 2.6 to M 5) including
recutting the thread
The tool must not be used for the following applications:
• Cutting steel threaded bolts
Any use beyond the intended purpose or any unauthorized modication
shall be considered improper. The operator shall be liable for damages re-
sulting from improper use.
Intended use also includes adhering to these operating instructions. They
must be read in full before use.
Warning!
Danger from sharp blades!
Handling sharp blades is dangerous. For this reason, make sure to handle
your tools with care when working.
Warning!
Risk of injury from ying parts!
Wear protective goggles when cutting cables and threaded bolts!
To Next Page
Loading...
