Toggle Switches
Gate Switch
Chord
Pressing an Audition or Preset button plays the chord for as long as the button is pressed.
When a gate signal is patched to the Gate input it will play the last chord played whether
auditioned or as a chord preset.
Orbit
Orbit plays each chord button in a sequence, starting with the first button you press and
continuously orbiting the audition star in a clockwise direction according to the internal clock
speed set in Arpeggio mode, or on every gate signal detected at the gate input. The Strum
knob can be used to adjust the sequence length from 1 to 8. When a gate signal is patched
into the Gate input the chord will play only when a gate signal is detected, each time a chord
button is pressed it will reset the sequence to that chord.
Arpeggio
Pressing a Preset Button will play the chord as an arpeggio, playing each note in sequence,
with the speed set by the Strum knob. When a gate signal is patched into the Gate input the
arpeggio steps through each note with each gate detected, the Strum knob in this instance
selects between different arpeggio styles.
Buttons Switch
The Button switch determines the function of the preset buttons and the Buttons Input cv
control.
Modal
Play chords using the Preset Buttons with each button representing a different mode as
found on the modal knob. A control voltage at the buttons input will select between different
modal positions.
Circle
Audition chords using the Preset Buttons with each button representing a different
transposition from the Circle knob. A control voltage at the buttons input will select between
Circle values.
To Next Page