kobalttools.com
6
SAFETY INFORMATION
CAUTION
preset at the factory for the maximum pressure of this unit. If the pressure switch or the relief
valve are tampered with, personal injury or property damage may occur.
injuries, do not touch the pump, manifold or transfer tube while the unit is running. Allow the parts
to cool before handling or servicing. Keep children away from the compressor at all times.
the safety instructions. Use a respirator mask if there is a chance of inhaling anything you are
spraying. Never directly inhale the compressed air produced by a compressor.
compressor. Never point the nozzle or sprayer toward a person or any part of the body. If the
spray penetrates the skin, serious injury may occur.
concrete, cement, or other masonry. This dust often contains chemicals known to cause cancer,
birth defects, or other reproductive harm. Wear protective gear.
cooling.
or worn spots and replace if necessary.
hearing loss.
or elevated position that could allow the unit to fall or be tipped over.
Preparing for Startup
WARNING: Risk of bursting. Too much air
pressure causes a hazardous risk of bursting. Check
the manufacturer’s maximum pressure rating for air
tools and accessories. The regulator outlet pressure
must never exceed the maximum pressure rating.
a. Set the ON/OFF switch (B) to the OFF position.
b. Turn the air pressure regulator knob (F) counter-
clockwise until it stops.
c. Attach air hose/accessories or air tools (not
included) to the quick coupler (C).
1
B
C
F
PREPARATION
To Next Page
Loading...
Need help?
General
