Kobalt 3DPCWB2013 - Table Top and Hanging Hooks Installation

13
ASSEMBLY INSTRUCTIONS
24. Insert the hanging hooks (33) into the holes on the
right side of the workbench.
24
DRAWER REMOVAL
1. Pull the drawer out of the workbench until the slides
are fully extended. Push the release lever down on
the right side of the drawer.
1
2. Pull the release lever up on the left side of the
drawer. Holding both levers, pull the drawer out until
the drawer releases from the drawer slides.
2
33
23. Place the wooden table top (32) onto the workbench
above the drawers.
32
23