5
ASSEMBLY INSTRUCTIONS
Important: Do not over-tighten the screws as this may result in stripping them. After the workbench is
completely assembled, fully tighten each screw.
1. Attach the left rear leg (1L) and the left front leg (2L)
to the side frame (4) using screws (AA). On the side
frame (4), ensure the edge with the hole is facing up.
Hardware Used
AA
M6x10 mm
Screw
x 4
1L
AA
4
2L
1
2. Attach the left side panel (3) using screws (AA).
Hardware Used
AA
M6x10 mm
Screw
x 4
3
2L
1L
3
2L
AA
2
To Next Page
Loading...
