22
OPERATING INSTRUCTIONS
18. ON/OFF Switch
For safety, the On/Off switch (B) is designed to
prevent accidental starts.
a. To operate the saw, press the lock-off button (A)
to disengage the lock, then squeeze the On/Off
switch.
WARNING
• The blade should reach full speed before it
contacts the work piece.
b. To turn off the saw, release the On/Off switch,
and allow the blade to come to a complete stop.
WARNING!
• Make the On/Off trigger switch childproof. Insert a small padlock or cable (not included)
through the hole in the On/Off switch, locking the switch and preventing children or other
unauthorized users from turning on the saw.
19. Chop Cuts
Chop cuts are used mainly for narrow pieces.
a. Remove the battery pack from the saw.
b. Turn the sliding-lock knob (AB)
counterclockwise to release the slide rail.
c. Slide the saw arm to the rear as far as it will go.
d. Tighten the sliding-lock knob.
e. Properly position the work piece. Make sure
that the work piece is clamped rmly against
the table and the fence. Make sure that the
work clamp (2) does not interfere with the
cutting operation.
f. Attach the battery to the saw.
g. Before turning the saw on, lower the saw arm
to make sure that the clamp clears the lower
guard and the saw arm.
WARNING
• Use a clamping position that does not interfere with the cutting operation.
h. Turn on the saw. Always allow the blade to reach full speed before cutting. Lower the saw
arm and make your cut.
i. Wait until blade comes to a complete stop before returning the saw arm to the raised
position and/or removing the work piece.
18
B A
hole
19
2
To Next Page
Loading...
Need help?
General