3-28
ï¼»3. MACHINE OPERATIONï¼½
3.10.2 TRAVEL PROCEDURES
ABOUT TRAVELING
• Confirm the travel motor position before traveling. When the travel motor is positioned at the front side, the travel
lever operation reverses.
The normal travel control can be performed when the travel motor is at the rear side of the machine and the front
idler is at the front side of the machine.
• Sound the horn to warn the workers in the working site.
ABOUT TRAVEL SPEED
During traveling, do not change the travel speed. Also, the travel speed should be set to the LOW (1st) speed when
the machine is traveling on a downhill, or being loaded to/unloaded from a trailer. A sudden change of the machine
stability could cause personal injury.
Before starting traveling operation move the control lock
lever to "UNLOCKED position" and set the bucket at the
height of 30 to 40 cm above the ground.
F: Forward traveling
N: Neutral (Stop)
R: Backward traveling
Forward/Reverse traveling
• Push (forward) or pull (backward) both the left and
right travel levers simultaneously.
Both the forward and reverse travel speed can be
changed by lever displacement.
Copyright©2021 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2LS00062ZE02] [0618CsCshWbYs]
To Next Page
Loading...
Need help?
General
