Kodak 6850 - Page 29

Calibrating the Printer
May 4, 2005 3-5
14. Check that the printer setup listed is the printer setup you want to use for
calibration.
• If the printer setup listed is the correct printer setup for your printer,
go to Step 19.
• If you want a different printer setup than what is listed, continue with
Step 15.
15. Click Change Setup.
The following dialog box appears.
NOTE: The appearance of this dialog box may vary, depending on your
printer export module.
16. Click Select to change the media file for your printer.
A file selection dialog box appears.
17. Select the media file and then click OK.
18. Click OK to close the dialog box.
19. Click Next.
The following dialog box appears.