8
~
SLIDE
TRAY
Furnished with the
projector
is a slide tray
that
holds
80
slides.
The
tray accepts
126
(28
x 28mm),
135
(24
x 36mm),
828
(28
x 40mm), and
127
(1
X x 1 X
-inch)
slides in cardboard,
glass, metal,
or
plastic 2 x 2-inch
mounts.
The
KODAK
CAROUSEL
Slide Tray accepts slides up
to
'/,
0
inch thick;
the
KODAK
CAROUSEL
Universal
Slide
Tray
accepts
slides
up
to
Ya
inch
thick
. Slides mounted with loose
or
sticky tape,
or
mounts
that have sharp glass corners are
not
recommended for use in the slide tray.
Slide-identification
numbers
are molded
onto
the tray.
As
the tray revolves, the
number
of
the slide being
shown
will be
opposite
the gate
index on the projector.
LOADING
SLIDE
TRAY
Check
to
be sure
that
the
LOCK
on the
bottom
of
the tray is
engaged in the
NOTCH
in the metal slide-retainer.
If
it
is
not,
turn
the retainer
until
the lock engages the notch in
the retainer.
Remove the lock ring
from
the
top
of
the tray
by
turning
it
in the direction
of
the
arrow
marked
UNLOCK;
then
lift
off
the ring.
Insert
a slide in each
slot
in the tray, with the
top
of
the picture down.
The
printed border
or
trademark side
of
each
cardboard-mounted
slide-or
the emulsion (dull) sur-
face
of
a slide mounted in glass, metal,
or
plastic-should
face the next lower number. For example, the bordered,
To Next Page
Loading...
