Kodak Carousel 850H User Manual

10
RANDOM SELECTION OF SLIDES IN TRAYS
To project a particular slide in a tray:
1,
2.
3.
Press the SELECT BAR firmly and hold it down.
Rotate the tray until the number of the slide you want to
project is opposite the gate index on the projector.
Release the select bar; the desired slide will be pro-
jected immediately.
REMOVING SLIDE TRAY
i.
2.
3.
With the projector turned on, press the SELECT BAR
firmly and hold it down.
Rotate the tray until the tray index bar is opposite the
gate index.
Release the select bar and then lift off the tray.
SHOWING SINGLE SLIDES
1.
With the projector turned on, insert a slide (correctly
oriented) into the projector gate. Push the slide down
into the gate as far as it will go.
. After viewing the slide, press the SELECT BAR to eject the
slide from the gate. You can now insert another slide
into the gate. (Slides up to 1% inch thick can be pro-
jected by this method.)
AFTER THE SHOW
1.
2.
3.
Remove the tray; then slide the power switch to OFF.
Lower the front of the projector by turning the elevating
wheel. Retract the leveling foot.
Retract the lens by turning the focus knob counter-
clockwise.
. Unplug the power and remote-control cords. Fold the
power cord in about 4-inch lengths and place it in the
cord compartment. Fold the remote-control cord by
placing the ends together and folding it in about 4-inch
lengths. Place it in the cord compartment.
SELECT BAR

Kodak Carousel 850H Specifications

General

Brand	Kodak
Model	Carousel 850H
Category	Projector
Language	English