Kodak COLORBURST 250 - Film and Print Care; Handling Camera and Film; Storing Developed Prints; Caustic Fluid Warning

CARE AND
STORAGE OF FILM
AND PRINTS
Leaving your film and camera in a hot
place such as a sunny window or a closed
car on a warm day may lead to reduced
picture quality. If you accidentally leave
the film and camera in a
hot place, allow
them to cool to normal temperature before
taking any pictures . If there is a film pack
inside the camera , wait approximately one
hour after the surface of the camera is cool
to
allow adequate cooling of the film.
Also
allow your film and camera to re-
turn to normal temperature if they have
been
left in a cold place such as a car
trunk during winter.
Store
your developed prints in a cool,
dry place. Print colors will remain un-
changed
longer if pictures are protected
from long exposure to bright light.
Each
picture is a sealed unit that con-
tains a caustic fluid . Never cut , trim, punc-
ture, tear , or separate the picture unit,
since this may allow some of the fluid to
escape
and come into contact with skin or
eyes. If there is any of this fluid or other
foreign material on the print surface, re-
move it with a damp cloth . Any cloth con-
taining fluid should then be discarded .
14
CAUTION
Picture units cont ain a caustic fluid .
Normally fluid will not appear. If it doe s,
alkali burn may result from direct con-
tact. Keep fluid away from eyes, mouth,
and skin. Avoid fluid
contact with fab-
rics,
carpeting , and furniture to prevent
stain.
In case of
contact with eyes, immedi-
ately flush
with plenty of water and get
medical attention. In case
of any other
contact , wash thoroughly at once .
•