Kodak COLORBURST 250 - Basic Operating Instructions; Inserting Batteries; Loading the Film Pack; Ejecting Film Cover

BATTERY·COMPARTMENT DOOR
LOADING
LINE
FILM COMPARTMENT
FILM
PACK
Basic Operating
Instructions
1
Pull down on the top of the BATTERY-
COMPARTMENT DOOR at the back of the
camera. Before
inserting the 4 AA-size
batteries (supplied), clean the ends with
a rough cloth; then insert the batteries
as shown by the diagram molded inside
the
battery compartment. Place the
batteries on top of the BATTERY STRAP. The
strap
helps you to remove the batteries
easily.
Close the
battery-compartment door
by pressing it against the camera body
until it snaps s ec urely into plac e.
2
Holding the film pack by the edges only ,
remove the
protective wrapping by
grasping the HAP and pulling in the
direction shown by the arrows . Be careful
not to squeeze the
pack , since this
could allow light to fog the pictures .
3
Open the FILM DOOR by pressing on the
FILM-COMPARTMENT LATCH , and lower the
door. Insert the
FILM PACK into the FILM
COMPARTMENT by lining up the orange
STRIPE on the pack with the orange LOADING
LINE on the camera. Close the film door
so that it latches securely at both s ide s
of the camera. The EXPOSURE COUNTER will
show the symbol !!J.
Fully depress the SHUTTER RELEASE and
allow it to return. The film cover will be
automatically ejected through the EXIT
SLOT . Then grasp the cover and remove it.
The exposure
counter will read " 1 ".