Kodak EasyShare DX7590

Getting started
2 www.kodak.com/go/support
Charging the battery
The Li-Ion rechargeable battery requires charging before first use.
1 Insert the battery into the charger.
2 Insert the plug that matches your electrical outlet.
3 Plug the charger into the outlet.
The indicator light turns red. When the indicator light turns green, remove the
battery and unplug the charger. Charging takes approximately 3 hours.
You can also charge the battery using an optional Kodak EasyShare printer
dock or camera dock. Purchase these and other accessories at a dealer of
Kodak products or visit www.kodak.com/go/dx7590accessories.
Inserting the battery
CAUTION:
Use only a Kodak EasyShare Li-Ion rechargeable battery.
1 Make sure the camera is turned off.
2 On the bottom of the camera, slide the battery
door and lift to open.
3 Insert the battery as shown. Push the battery
completely into the battery compartment.
4 Close the battery door.
1 2 3