www.kodak.com/go/support 45
5 Troubleshooting
Camera problems
Status Solution
Camera does not
turn on
■ Make sure the battery is properly installed (page 1).
■ Insert a charged battery.
Camera does not turn
off
Camera buttons and
controls do not
function
In Review, a blue or
black screen is
displayed instead of
a picture
■ Transfer
all
pictures to the computer (page 12).
■ Take another picture. If the problem continues, change the image
storage location to internal memory.
Pictures remaining
number does not
decrease after taking a
picture
■ Continue taking pictures. The camera is operating normally.
(The camera estimates the number of pictures remaining after each
picture is taken, based on picture size and content.)
Picture orientation is
not accurate
■ Set the Orientation Sensor to ON.
Flash does not fire
■ Check the flash setting, and change as needed.
NOTE: The flash does not fire in all modes.
Storage location is
almost or entirely full
■ Transfer the pictures to the computer (page 12).
■ Delete pictures from the card or insert a new card.
■ Change the image storage location to internal memory.
To Next Page
Loading...
Need help?
General
