Troubleshooting
www.kodak.com/go/support
51
Direct printing (PictBridge enabled printer) problems
Picture is too light ■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (see page 9).
■ Move so that the distance between you and the subject is within the
effective flash range.
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Auto and SCN-Custom modes, adjust the Exposure Compensation
(see page 36).
Status Solution
Cannot find the
desired picture
■ Make sure you’re not in Favorites mode.
■ Use the Direct print menu to change the image storage location.
The Direct print menu
interface turns off
■ Press any camera button to redisplay the menu.
Cannot print pictures
■ Make sure there is a connection between the camera and the
printer (see page 45).
■ Make sure the printer and the camera have power.
Camera or printer
display an error
message
■ Follow the prompts to resolve the issue.
Status Solution
To Next Page
Loading...
Need help?
General
