Setting Up Your Printer
38 www.kodak.com/go/aiosupport
NOTE: Check with your cable television provider to make sure you can send and
receive faxes over your digital telephone service.
Connecting the printer to a standard telephone line
If you have a dedicated phone line that does not receive any voice calls, connect your
printer to the
Line-In on the printer as described below.
1. Connect one end of the phone cord supplied with your printer to your telephone
wall jack and the other end to the port labeled
Line-In.
2. When the phone rings your printer is set to answer automatically after the
number of rings set in the
Rings to Answer setting. See Specifying rings to
answer, page 40.
3. If you use an answering machine, connect your answering machine plug into the
port labeled
EXT-Out on your printer. Set the number the of rings on your
answering machine to a lower number of rings than the
Rings to Answer settings
on your All-in-One printer. If you are using a dedicated telephone line to send or
To Next Page
Loading...
