Networking Your Printer
10 www.kodak.com/go/aiosupport
Setting up an IP Address
IMPORTANT: You should only need to set up an IP Address for your printer if you are
having a problem with connecting. Typically, it is not necessary to set up an
IP Address. This procedure is for advanced users who know how to obtain
the IP Address for the printer.
All IP Address entries have the following format: 000.000.000.000. Within each
three-digit grouping, the number must be right-justified. If an address or subnet
mask has only one or two characters between the periods, include one or two
leading zeros in front of that number. For example:
To set up your IP Address on the printer:
1. Press Home.
2. Press to select Network Settings, then press OK.
3. Press to select Advanced IP Address Setup, then press OK.
4. Press OK again to continue.
5. Select one of the following, then press OK:
• Dynamic (DHCP)
• Manual (Static)
6. If you selected Manual (Static), you are prompted to enter an IP Address, a
Subnet Mask, a Gateway Address, and a DNS Server address. Press OK after
each entry. Use the navigation buttons to enter each digit of the numbers.
Consult your Internet service provider or network administrator for more
information.
The address as it may appear
in your documentation
How to enter the address
in the printer menu
149.89.138.149 149.089.138.149
149.2.40.149 149.002.040.149
To Next Page
Loading...
Need help?
General
