A-61654/ISIS December 2009 11
NOTE: The Scan Area dialog box is only available when Fixed to
Transport, Relative to Document, or Photo with ROI is
selected on the Main tab.
Page Size ⎯ the default paper size is set when a scanner is first
selected. You can choose a different paper size using the drop-down
list.
NOTE: Page Size also appears on the Layout tab. If you make a
change on the Scan Area dialog box, the same selection
appears on the Layout tab and vice versa.
Page Layout
• Portrait: displays the image orientation in the shape of a
conventional portrait, where height is greater than width.
• Landscape: displays the image orientation in the shape of a
conventional landscape painting, where width is greater than height.
Area
• Snap ⎯ enable this option to control the dimensions of the preview
area to fixed 0.3175 cm (1/8-inch) increments. This option is not
available in Pixels mode.
• X: the distance from the left end of the scanner to the left-edge of the
scanning area.
• Y: the position from the top end of the document to the top end of the
scanning area.
• Width: the width of the scanning area.
• Height: the height of the scanning area.
Units — select whether you want the area to be defined in Pixels,
Inches or Centimeters.
To Next Page
Loading...
