A-61654/ISIS December 2009 19
Scanner tab The Scanner tab provides the following options:
Document Feeder
Paper Source — ADF (automatic document feeder). All documents will
be scanned from the input elevator.
Feeder Position — select one of the following input elevator positions:
• Normal: the input elevator is the highest position. This position is
recommended when you are scanning 25 sheets or less from the
input elevator.
• 100 Sheets: this selection is recommended when you are scanning
between 25 and 100 sheets from the input elevator.
• 250 Sheets: this selection is recommended when you are scanning
between 100 and 250 sheets from the input elevator.
• 500 Sheets: this selection is recommended when you are scanning
between 250 and 500 sheets from the input elevator.
Automatic Start Transport — if selected, the scanner will wait for up
to 10 seconds for documents to be placed in the input elevator before
scanning will begin.
Timeout — allows you to set the amount of time the scanner will wait
after the last document enters the transport before the transport timeout
action is taken. You can specify a time delay setting from 1 to 300
seconds.
To Next Page
Loading...
