Kodak Mini Digital Film Scanner - Loading Slides into Kodak Scanner; Continuous Loading Feature for Kodak Scanner; Using the Kodak Mini Digital Film Scanner

12
13
10. CONTINUOUS LOADING (SLIDES
AND/OR FILM)
This useful function allows you to continue feeding new
negatives or slides into the ilm scanner without the messy
and frustrating process of removing the tray and repositioning
your ilm or slides every time.
1. Load the empty ilm negative
or slide holder tray into the
ilm scanner.
2. Feed one end of the ilm into
the tray from the right side.
3. Continue feeding the ilm
through the tray until it
emerges from the left side.
You can stop at each image
along the way and scan if
you’d like, or just keep
feeding the negative until you
ind the image you want to scan.
11. USING THE SCANNER
NOTE: Before loading ilm into the scanner, use the cleaning
wand and gently insert it into the ilm slot to clean o the lens
and backlight panel. This will ensure that the image you capture
turns out clear without any blemishes.
1. Hold the slide toward the light
and face the front of the slide
toward you.
2. Take the slide holder out and hold
it with the latch facing away from
you so that the loading arrow ◄
points left. Open the latch; place
the slide into the recessed area
(you can also use this area to
hold the dierent size ilm adapters
if necessary); and then close the
latch, making sure to press down
around the edges so that it snaps
securely into place.
3. Insert the slide holder into the slot
on the right side of the ilm scanner
as pictured.
9. LOADING SLIDES