3-4 A-61662 October 2011
Accelerated
scanning (VRS only)
If you want to improve the scanning throughput at 300 dpi (or greater),
you can change your acceleration scanning setting. To do this:
1. If using Windows 7, from the Taskbar, click the Up arrow to access
the Admin Utility.
2. Right-click the VirtualReScan icon.
3. Select Admin Utility. The Virtual ReScan Administration Utility
dialog box will be displayed.
4. Select the Accelerated Scanning tab.
5. Move the slider bar to Acceleration: Maximum.
6. Click Save.
NOTE: Changing this setting may produce a slight reduction in image
quality.
To Next Page
Loading...
