A-61662 October 2011 5-5
Picking Rectangle screen The Picking Rectangle screen provides the following options:
Front Side/Back Side — allows you to define the area to be imaged by
selecting a value in the Width and Height drop-down boxes and its
offset from the upper left corner of the image (defined by the Top and
Left values). The picking rectangle is relative to the cropped image
such that a value of Top=0.00 and Left=0.00 will always be the very left
corner of the lead edge of the page that was fed into the scanner. The
resulting image is a cut out of the original, larger image. Therefore, if
you scan a letter-size page and have Letter paper size selected, you
will get a rectangular cut out from that image, the location and size of
which is determined by these values.
To Next Page
Loading...
