88
Connecting to your Printer
1. Make sure the printer is turned on.
2. Connect one end of the supplied micro USB
cable to the USB port on your camera.
3. Connect the other end of the micro USB
cable to the USB port on the printer.
If the camera is not connected to a PictBridge
compatible printer, the following error message
will appear on the LCD screen.
The error message above will also appear
if the USB mode is set incorrectly, in
which case you should disconnect the
micro USB cable, check the USB mode
settings, ensure that the Printer is turned
on, and then try connecting the micro
USB cable again.
To Next Page
Loading...
