Kodiak X2 User Guide
2
QUICK START GUIDE: FIRST THINGS FIRST
1. When you unbox your Kodiak X2, PLEASE DO NOT throw away the packaging. It may come
in handy down the road in case of damage from shipping or handling, or any other issues re-
quiring a return.
2. Charge your Kodiak X2 to 100% by connecting the wall adapter into the AC Charge Input
on the left side of the unit. Ensure that the Dualink Parallel Switch is in Solo Mode prior to
connecting to the wall to charge by pushing the switch fully to “S”. Charging can only be done
while in Solo Mode. Leave the Main Power Button on the LEFT side of the unit ON during
charging, this will allow the Kodiak X2 to reach 100% and balance the internal multi-cell battery
pack. Never charge a Kodiak X2 if the temperature is below 32°F. For instructions on connect-
ing 2 Kodiak X2’s together, see Using Your Kodiak X2 in Dualink Parallel Mode.
3. When your Kodiak X2 is fully charged, plug a device into each output to make sure that
nothing was damaged in shipping and handling.
4. It is EXTREMELY IMPORTANT that the Kodiak X2 not be left stored at a very low battery lev-
el, or run until it turns off and not recharged within a day or two. Not doing so can permanent-
ly damage the battery and is not covered under warranty.
To Next Page
Loading...
Need help?
General