Kodiak X2 User Guide
8
CHARGING YOUR KODIAK X2 POWER STATION
General Information
The Kodiak X2 can only charge in Solo Mode, as indicated by the Dualink Parallel Switch being
pushed completely to the right below the letter “S”. This switch is located below the charge
ports on the left side. Ensure this is done BEFORE connecting a charge source. Because the
Kodiak X2 must be charged in Solo Mode, never attempt to charge a Kodiak X2 while it is con-
nected to another Kodiak X2 in Parallel Mode, doing so will void the warranty and may result in
fire, property damage, or bodily harm. While charging, leave the Main Power Button in the ON
position, this will allow the Kodiak X2 to reach 100% and balance the internal multi-cell battery
pack.
Temperature
The Kodiak X2 should only be charged when the temperature of the battery is above 32°F. The
battery will suffer irreparable damage if charged when the temperature of the battery itself is
below 32°F. We have included temperature sensors in the Kodiak X2 battery pack that can be
read by our mobile app to help you if you suspect that the ambient temperature is close to that
level. If it is below freezing, simply allow the Kodiak X2 to warm up for an hour or two before
charging. Similarly, charging the Kodiak X2 when it’s too hot (above 104°F) can also degrade
and damage the battery.
When charging your Kodiak X2, the LCD screen will indicate the amount of power being sent
to the battery and an estimated charge time. This estimated charge time is based on the re-
al-time power input and output shown on-screen, and it will change as the average charge or
discharge rates fluctuate.
Charging From the Grid (AC Wall Outlet)
You can charge your Kodiak X2 from normal AC power sources. The wall adapter provides up
to 1080 watts of charge power. Because of this extremely fast charge rate, only one charge
source at a time will charge the battery: either the grid OR solar input, not both at the same
time. If both are connected, AC charging will be prioritized and solar charging will be disabled.
In the event the grid goes down and AC charging is lost, solar charging will automatically be
re-enabled until the system is either charged or grid power is restored. Important Note: The
Inergy Quick Wall Charger that is used for the Flex 1500 Power Station or Apex Power Station is
NOT compatible with the Kodiak X2 and should not be used. It may damage your system.
Charging With Solar Panels
In general, with solar panels in a shadow-free environment, no obstructions, and clear sunlight,
it’s common to see a charge rate of about 80% of the wattage of your solar panel array. Utiliz-
ing solar energy can be as simple as pointing your panels at the sun. However, there are many
variables that can affect the panel’s performance, and there are a few “best practices” to know.
For help charging with solar panels and configuring your solar arrays correctly, please call us
(see Contact Us) and we’ll be happy to help you out. Here are a few of the most common vari-
ables that affect performance, and some tips and tricks to help you maximize your results:
To Next Page
Loading...
Need help?
General