KV1000 Constant Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
- 3 -
1.3. Instrument Specifications
2. Safety Information and Warnings
Safety Considerations. The use of this equipment may involve hazardous materials and operations. This manual does not purport
to address all of the safety problems associated with the use of this equipment. It is the responsibility of any user of this equipment
to investigate, research, and establish appropriate safety and health practices and determine the applicability of regulatory
limitations prior to use.
Equipment Modifications and Replacement Parts. Any modification or alteration of this equipment from that of factory
specifications is NOT recommended because it voids the manufacturer warranty, product safety, performance specifications,
and/or certifications whether specified or implied, and may result in personal injury and/or property loss. Replacement parts must
be O.E.M. exact replacement equipment.
Unit Design. This equipment is specifically designed for use in accordance with the applicable standard test methods listed in
section 1.2 of this manual. The use of this equipment in accordance with any other test procedures, or for any other purpose, is
not recommended and may be extremely hazardous.
Over Temperature Protection. This unit is equipped with Over Temperature Protection (OTP) circuitry to prevent overheating.
The unit will automatically interrupt power whether equipment malfunction or operator error causes the temperature to exceed
either 20 °C above the set point or the maximum recommended temperature range. The power can only then be restored by
identifying and correcting the problem, Allowing the unit to return to normal operating temperatures, and resetting the power to the
unit.
Chemical Reagents Information. Chemicals and reagents used in performing the test may exhibit potential hazards. Any user
must be familiarized with the possible dangers before use. We also recommend consulting the Material Data and Safety Sheet
(MSDS) on each chemical reagent for additional information. MSDS information can be easily located on the internet at
http://siri.uvm.edu or http://www.sigma-aldrich.com.
3. Getting Started
The instructions for preparing the equipment assume that the user is aware of the contents of this document, which lists the
warranty conditions and important precautions.
3.1. Packing List
• KV1000 Digital Constant Temperature Kinematic Viscosity Bath
• Round Viscometer Port Cover (6)
• Thermometer Holder (2)
• Tapered Plug (2)
• KV1000-Manual KV1000 Operation and Instruction Manual
• IEC Power Cord
To Next Page
Loading...