TP-6805 8/15 129Section 7 Disassembly/Reassembly
6. Remove two screws and remove the front panel.
SeeFigure7-5.
GM72523
1. Remove 2 screws
1
Figure 7-5 Front Panel (air intake end panel)
7. Unplug the carburetor heater (if equipped) from the
120 VAC receptacle.
8. Verify that utility power to the generator set terminal
block has been disconnected.
9. Disconnect the generator set engine starting
battery, negative (--) lead first.
10. Disconnect output leads or load circuit cables at the
field-connection terminal block.
11. Remove two nuts and lift off the exhaust end panel.
SeeFigure7-6.
GM72523
1
1
1. Remove 2 screws
Figure 7-6 Rear Panel (exhaust end panel)
12. From the inside of the enclosure, remove four nuts
securing the left side panel. See Figure 7-7.
13. Pull the panel up and off.
2
2
1
ADV-7876
1. Left side panel
2. Remove 4 nuts
Note: Bulkhead design may
vary.
Figure 7-7 Left Side Panel
To Next Page
Loading...
