Kohler 20RES - Page 89

TP-6735 7/17 89Section 6 Disassembly/Reassembly
4. Original design, see Figure 6-3. Remove the
exhaust duct panel over the muffler:
a. Remove four screws. See Figure 6-3.
b. Remove the top exhaust panel.
1
GM66564
1. Exhaust duct panel. Remove 4 screws
2. Top exhaust panel. Remove 2 screws.
1
2
Figure 6-3 Heat Shield (original)
5. Revised design with thermal cover, see Figure 6-4.
Remove the thermal cover:
a. Loosen and remove the locknuts from the front
and rear hinge brackets.
b. Remove the thermal cover.
GM81036--C
1. Thermal cover
2. Screw. Do not overtighten; allow to pivot.
3. Locknut(s)
1
3
3
2
2
REAR HINGE BRACKET VIEW
FRONT HINGE BRACKET VIEW
SEE FRONT HINGE
BRACKET VIEW
SEE REAR HINGE
BRACKET VIEW
Figure 6-4 Thermal Cover (revised design)