EasyManuals Logo

Kohler Command Pro EFI ECH940 User Manual

Kohler Command Pro EFI ECH940
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Troubleshooting
24 62 690 13 Rev. AKohlerEngines.com
TROUBLESHOOTING GUIDE
When troubles occur, be sure to check simple causes which, at fi rst, may seem too obvious to be considered. For
example, a starting problem could be caused by an empty fuel tank.
Some general common causes of EFI engine troubles are listed below and vary by engine specifi cation. Use these to
locate causing factors.
Engine Cranks But Will Not Start
Battery connected backwards.
Blown fuses.
Clogged fuel line or fuel fi lter.
Empty fuel tank.
Faulty ignition coil(s).
Faulty spark plug(s).
Fuel pump malfunction-vacuum hose clogged or
leaking.
Fuel shut-off valve closed.
Insuffi cient voltage to electronic control unit.
Interlock switch is engaged or faulty.
Key switch or kill switch in OFF position.
Low oil level.
Quality of fuel (dirt, water, stale, mixture).
Spark plug lead(s) disconnected.
Engine Starts But Does Not Keep Running
Faulty cylinder head gasket.
Faulty or misadjusted throttle controls.
Fuel pump malfunction-vacuum hose clogged or
leaking.
Intake system leak.
Loose wires or connections that intermittently ground
ignition kill circuit.
Quality of fuel (dirt, water, stale, mixture).
Restricted fuel tank cap vent.
Engine Starts Hard
Clogged fuel line or fuel fi lter.
Engine overheated.
Faulty ACR mechanism (Recoil Start).
Faulty spark plug(s).
Flywheel key sheared.
Fuel pump malfunction-vacuum hose clogged or
leaking.
Interlock switch is engaged or faulty.
Loose wires or connections that intermittently ground
ignition kill circuit.
Low compression.
Quality of fuel (dirt, water, stale, mixture).
Weak spark.
Engine Will Not Crank
Battery is discharged.
Faulty electric starter or solenoid.
Faulty key switch or ignition switch.
Interlock switch is engaged or faulty.
Loose wires or connections that intermittently ground
ignition kill circuit.
Pawls not engaging in drive cup (Recoil Start).
Seized internal engine components.
Engine Runs But Misses
Fuel system issue (Fuel Injectors).
Engine overheated.
Faulty spark plug(s).
Ignition module(s) faulty.
Incorrect crankshaft position sensor air gap.
Interlock switch is engaged or faulty.
Loose wires or connections that intermittently ground
ignition kill circuit.
Quality of fuel (dirt, water, stale, mixture).
Spark plug lead(s) disconnected.
Spark plug lead boot loose on plug.
Spark plug lead loose.
Engine Will Not Idle
Engine overheated.
Faulty spark plug(s).
Idle speed adjusting screw improperly set.
Inadequate fuel supply.
Low compression.
Quality of fuel (dirt, water, stale, mixture).
Restricted fuel tank cap vent.
Engine Overheats
Cooling fan broken.
Excessive engine load.
High crankcase oil level.
Lean fuel mixture.
Low crankcase oil level.
Cooling system components clogged or restricted.
Engine Knocks
Excessive engine load.
Hydraulic lifter malfunction.
Incorrect oil viscosity/type.
Internal wear or damage.
Low crankcase oil level.
Quality of fuel (dirt, water, stale, mixture).
Loose/worn pulley/clutch on crankshaft PTO.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler Command Pro EFI ECH940 and is the answer not in the manual?

Kohler Command Pro EFI ECH940 Specifications

General IconGeneral
BrandKohler
ModelCommand Pro EFI ECH940
CategoryEngine
LanguageEnglish

Related product manuals