Electrical System
152
24 690 01 Rev. SKohlerEngines.com
FUSES
This engine has 3 blade type automotive fuses.
Replacement fuses must have same rating as blown
fuse. Use fuse chart below to determine correct fuse.
Wire Color Fuse Rating
2 Purple Wires 30-amp Fuse
1 Red Wire w/Black Stripe
1 Red Wire w/White Stripe
10-amp Fuse
2 Red Wires 10-amp Fuse
Fuse Replacement
1. Shut engine off and remove key.
2. Locate fuse holders.
3. Remove fuse cover and pull out fuse. Inspect
condition of fuse.
4. Inspect fuse for a solid fusible link or a broken fusible
link. Replace fuse if fusible link is broken. If you are
not sure if fusible link is broken, replace fuse.
5. Insert fuse into fuse holder until it is seated properly.
Install fuse cover.
6. If replacement fuse fails, there is a problem within
circuit. Diagnostics are required. Identify which circuit
is aff ected (see EFI System for electrical schematic)
by identifying failed fuse/circuit. Perform
troubleshooting procedures appropriate for circuit
fuse that failed.
7. Install fuse holder into fuse cover.
To Next Page
Loading...
